SmartFit Example
<< Click to Display Table of Contents >> Navigation: Nesting > Auto Nesting > Auto Nesting Options > SmartFit Example |
4 sizes of part to nest, all 350 wide by 500, 2500, 3100 and 8000 long:
Nesting across 2 plates each of 3 sizes:
•2x 2400x1200,
•2x 3000x1500
•2x 6000x3000:
(One of the 4 parts to nest 8000x350 is larger than all the plates- it will not be nested as it does not fit)
Without SmartFit
Nesting the plates in the order presented: in this case smallest to biggest, results in smallest parts being nested into the smaller plates first, resulting in 5 plates used, including one of the largest plates being only half-utilized:
Without SmartFit: plates ordered smallest to largest
If we reverse the order of the plates, biggest to smallest, then the two largest plates are used, and one of them is only a fraction used; it would have been better to nest this on a smaller plate.
Without SmartFit: plates ordered largest to smallest
With SmartFit
If the setting is changed to SmartFit (or one of its variants):
We get one big plate filled up, one small plate mostly full:
(the order the plates are presented with this setting does not affect the outcome)
With SmartFit: plates order does not affect result.
Large parts are nested on the smallest plate that fits them, and smaller parts are nested around them.