A frozen plate must not change. If any earlier run's part that the new combining run would take over is nested on a frozen plate, PrimeCut NE refuses the whole nest request before changing anything.
Chart 3 - a frozen plate holds an earlier run's part
The message lists each plate:
Combining run 9002 cannot be brought in: earlier runs' items of its parts are nested on frozen plates, which it must not change.
Plate 1234-A (5678): P1 on WO-1234
Unfreeze these plates, then bring the combining run in again.
What to do
•Unfreeze the plates listed.
•Send the combining run from PowerFab again. Nothing from the refused attempt was kept, so it imports as if for the first time.
See Also